PDA

View Full Version : Alfa 164 donor parts to keep


Shaun II
February 16th, 2008, 06:40 AM
John posted a thread once listing useful parts to keep from the 3L donor car:

Engine
Gearbox
Gear linkage + lever
Management loom
ecu
ignition amplifiers(near battery tray)
evap valve(in lh front wing, 24v)
Air flow meter
power distribution block on lh front bulkhead
clutch slave cylinder
fuel pump(in tank)
brake calipers
discs(if mint)
handbrake cable
male and female elec plugs from the doors
battery cable
coloured multiplugs under the dash
lambda probe from cat
fuses, relays etc

Any additions to this and anybody need anything, I am keeping the engine, box and brakes? Car has to be gone by the end of the month.

Haven't had chance to investigate yet but engine runs fine cold, misses under load when warm/hot and will not restart. Coil? Car is a 12V 1989 but has a lambda, possibly a cat and for sure, a mouse.

pimms
February 16th, 2008, 08:35 AM
Maybe you want to use the small squire lights in the side doors, look almost the same as the Stratos ones ??

strat6v
February 16th, 2008, 10:44 AM
quite a few nice little rubber mounts. They are like a grommet with a centre sleeve and top hat end section, useful for isolating components from vibration.