M12 Conversion Studs

[Chris J]

I've just had some conversion studs delivered from Walkers (Lancia and Techno 2). The studs come in three lengths:

68mm
82mm
100mm

http://www.walkers-garage.co.uk/shop/

The studs have a proper shoulder between the threads of either end and are high tensile. (not dodgy poor quality ones with no shoulder)

Studs with M12 1.25 (Fiat/Lancia) at either end are available, as are M12 1.5 threaded studs.

There are also studs with 1.25 at one end and 1.5 at the other, but I'm not sure whether this is 1.25 at the hub or nut end of this type of stud?

The type that I've had delivered are 82mm M12 1.25 at either end. See photo of the actual studs supplied:

[Sando]

I use these too. Top Quality with rolled threads.
Bobster

[Chris J]

I use these too. Top Quality with rolled threads.
Bobster

I should have asked you Rob? I was thinking of having some made up until I realised they were available off the shelf.

[Sando]

I'm sure I've put something here or posted a few times in the past that they were available and top quality. Too many good posts to search through now. It was probably about 5 years ago!
They do vey high quality wheel spacers in 4 and 5 stud too
Rab

[Chris J]

Found it Rob:

http://www.stratossupersite.com/forum/showthread.php?t=649&highlight=studs

I was 'between Stratos' back then, so I probably took no notice.