fiat x19 parts

[sunbeamlotus]

i own a company in swansea south wales that brakes and strips MR2's and Fiat X19s

some of the parts i have

mint engine covers
mint boots
leather seats and door card
2 mint doors with working e/w
hubs
brakes
engine
rear 1/4 panels
roof x2
dash
switchs
locks

everthing must go! we have a small stand at this weekends swansea classic car show

Retro inc custom steel fabrication and restoration

Retro inc custom steel fabrication and restoration are now stocking off the shelf ready to fit smooth body panels for any car!

We smooth and prime all are panels in house to a very high standard we don’t use fibreglass in any of are steel products. We seam weld every panel using are large range of steel filler panels which are all pre cut to size ready to weld. Why spend money for poor fibreglass smoothing panels when at such a good price you can buy such a good product as are boot.

We also carry out smoothing of bumpers and doors along with bad boy bonnets again seam welded and hand crafted to a very high standard. Are bonnets are made buy stretching the front lip of the bonnets with a hammer and dolly then welding in hand shaped and rolled new front lips.

All are boots are seam welded (NO FIBREGLASS) and only the very best products used to smooth them. All panels come complete in primer ready to paint with glass.

VW polo new shape and old £75
Ford fiesta old shape£75
Ford fiesta new shape £120
KA £65
Focus£120
Golf£120
306£65
206£120
rover 25 £145
seat leone £65
Civic £120
Saxo£120
C2 £120
106 £65
clio£120

Are boots work on an exchange so all prices + £40 until your old boot is returned!

You can buy the panels compete if you wish to keep your old panel but at cost.

If your car is not listed we can smooth any panel on any car!

Please be free to contact us for any body work from smooth boots to twin engine minis to custom VW camper vans


RETRO inc
Custom steel
Smooth body panels and boots
Clydach Swansea
South wales
Tel 07773745177

Email retro_car_builder@hotmail.co.uk


My boots work on a exchange you give me your boot and I give you a smooth one back there and then no waiting for your car to come back.

Prices start at £65 for a ka to £120 for a focus I also do saxo 106 c2 polo golf any boot any panel any car.

Prices are +£40 until your old boot is returned or pay £30 and I will fit the boot for you so you don’t even get your hands dirty.

Pm me for any information about any job you like.

Or ring Tel 07773745177

I start with a standard boot this one being a ztec s boot first its stripped of everthing even the glass

http://img240.imageshack.us/img240/4157/bootstart0ug.jpg



Then a plate is made and seam welded in to the area to be filled. The plate is painted with zink etch primer to stop rust


http://img240.imageshack.us/img240/9831/weldin4zp.jpg


Then only the best filler and products are used to smooth out any dents or bumps in the panel

http://img161.imageshack.us/img161/3149/filler8zn.jpg


The boot is then primed and glass refitted all that needs doing is for any trim or wires to be reconnected.


http://img128.imageshack.us/img128/1599/greyprim9kw.jpg

http://img128.imageshack.us/img128/5456/greyprimer3if.jpg


http://img128.imageshack.us/img128/5319/insidegrey3nr.jpg

[rutthenut]

It would be more useful to readers of this forum if you indicated which X19 parts you have, and left out the advert for chav-style bodywork mods that are most definitely not applicable to the Stratos...

If you have X19 switches, they could well be of interest.

J.R.

[sunbeamlotus]

yes i have switchs i have 2 complete dash's one from a s1 x19 and the other from a s2 what switch are you looking for ?

[rutthenut]

yes i have switchs i have 2 complete dash's one from a s1 x19 and the other from a s2 what switch are you looking for ?

I could do with replacing the switches in my Stratos replica.

Would need the up/down headlamp switch, fog lamp switch, heater fan switch and maybe interior lamp switch. Also the simple surrounds that the switches clip into.

If you have these available, could you post pictures as well as asking price?

Also, do you have the 'fibre optic' lighting for these switches?

[sunbeamlotus]

i came across a fog switch this morning when i was cleaning up and i think there was a interior lamp switch i will have a look i know i sold some at the weekend at a car show. i will have a look in the morning.

on another note i came across hubs with lower arms and brakes with the drive shafts off a 1500cc x19 if anyone want them. also a set of rear struts

[guy mayers]

These are the X19 bits that are of use to Stratos people.
Headlights, headlight trim rings and mounting nest (but not the pods). Headlamp motors and adjustor rods if not seized solid.
Overcentre roof catches plus the latch plates they clip onto.
Matching sets of door handles/boot/engine cover release levers WITH keys.
Steering column with ignition lock and key. Door lock mechanisms and body catches.
Radiator if good, fans no use.
Switches from the 1300 model, the black rocker type complete with surrounds. Column stalks from 1300. Stainless steel expansion tank.
Choke lever knobs from 1300 - found by the handbrake.
If I've missed anything I'm sure someone else will add to the list. The rest is junk to us!
Cheers
Guy

[kolynos]

Could do with a stainless steel expansion tank & door locks with key, any hope...

[sunbeamlotus]

right then some photos of the parts you asked for

http://img145.imageshack.us/img145/8775/tank7xu.jpg

http://img135.imageshack.us/img135/8053/switch22sg.jpg

http://img142.imageshack.us/img142/7629/switch9ws.jpg

http://img135.imageshack.us/img135/5228/doorlock3ai.jpg

i have keys for the door locks

s/s tanks are around £45 but are out of stock at the moment but i have a good plastic one.

any other parts that your after?

[kolynos]

How much for the door locks?

[sunbeamlotus]

make me offers on the parts you want

[rutthenut]

Thanks for providing the photos. Unfortunately the switches are of the wrong sort for use in the Stratos kits. But looks like you may have a buyer for the locks...

J.R.

[sunbeamlotus]

well the locks are there ready to be used may even have another set if i can find the keys

anyone got a photo of the switch's your after? .........


any other parts your after?

[rutthenut]

Guy listed all the X19 parts that would be of interest to anyone with a Stratos kit.

Switches on the Strat are shown in the following Gallery picture
http://www.stratossupersite.com/photos/showphoto.php?photo=162&sort=1&cat=all&page=1

Cheers,
John

[sunbeamlotus]

seem the switch before but can remember where

are they the same size as the lucas ones used in BL cars. they look a little fatter