need some bits.....

[Swamprat33]

looking for a complete (working) 164 24v (or 12v clover) gearbox with bell housing, actuating lever and clutch cylinder with bracket if poss.
Would also like a clutch if anyone has one spare.

Need this to fit to my 12v 'cloverleaf' engine.

Also looking for a Bosch coil pack and the throttle position sensor from a 155 V6.

Please contact me with prices.

Many thanks

Tim

[Matt No VAT]

If you can tell me how to identify a 12v cloverleaf gearbox from a standard 12v gearbox I'll check the three spare gearboxes I have. (without opening them up!!!!)

[Swamprat33]

Hi Matt, The 12v Cloverleaf box is essentially a 24v clutch.
I would be happy with eirther a 12v clover or 24v box.

Standard 12v boxes are not as strong ast the 24v and use a smaller clutch.

I have found a good, low mileage 24v box quite close to me, but it is £300.

Seems a little pricey to me though.

Cheers

Tim

[Matt No VAT]

£300.... Ouch!! :eek:

[Swamprat33]

Indeed. Most complete 164's go for not much more than that.
Then there is another £150 for a new clutch :(

Tim

[Chris J]

Here's a 155 V6 and box:

http://www.pistonheads.com/sales/71587.htm

'Don't know if it's of any use? It does say "gearbox available".

[CorseChris]

Hey Tim, I could do with the engine for my 155 I think.....and this would probably supply the other bits you need as well....and its not far from me. Fancy some sort of buy to split?

[Swamprat33]

Hi Chris, I thought that the 155 an 156 gearboxes were not suitable for use with a 164 engine.

Tim

[CorseChris]

The V6 block is basically the same but I couldn't say for sure.