PDA

View Full Version : Wanted - 12V alfa V6 odd parts

CorseChris
May 24th, 2005, 01:06 AM
In case anyone out there has these bits spare, I'm looking for the following please.

Crank pulley with poly-v and single V drives.
Bracketry and idlers/pulleys from an A/C compressor installation.

Any other odd bits you might not need but think could come in handy for mounting a compressor to the V6 motor. My donor V6 didn't have A/C so I'm missing these bits. If yours did, maybe we can swap?

Thanks!
chris.richard
May 24th, 2005, 01:41 AM
Bracketry and idlers/pulleys from an A/C compressor installation.



I've got these from a24v I think - if I can still find them! :rolleyes:
I suspect they'll be the same.
CorseChris
May 24th, 2005, 02:11 AM
Ooh - brilliant!


...will you be at Abingdon Chris? (subtle hint #4).... :)
chris.richard
May 24th, 2005, 04:07 AM
No, not this year I'm afraid, but there may be ways...
CorseChris
May 24th, 2005, 09:07 AM
Thanks Chris. Once you've had a chance to find what you have, maybe we can come up with somehting that's not going to be too much bother for you. Packing up lumpy chunks of metal can be a pain.......

...although the best parcel I've done to date was a spare pair of Marcos Mantula doors!
guy mayers
May 24th, 2005, 10:02 AM
I may also have these bits from a 12v - I'll bring them to Abingdon **IF** I make it there!
Guy
CorseChris
May 25th, 2005, 12:41 AM
Guy - thank you. I hope you make it regardless of whether you can bring the bits or not though.
CorseChris
December 5th, 2005, 02:46 AM
Folks,

Brought this to the top again as I now need the crank pulley fairly soon. Dave W reckons he can help...but he is still out of the country. What I'm looking for is a crank pulley from a 12V motor that has a single V pulley section AND a poly V section on it. They do exist! I have a couple of dual single V types available so if anyone has one of what I'm looking for and could swap perhaps? AFAIK, they are balanced as an entity so won't affect overall engine balance (unless your engine has had after-market work done on it including a re-balance).

Worst-case would be a pulley that only has poly-V sections, but this would still be a lot more use to me than what I currently have a surplus of!

TIA
CorseChris
December 19th, 2005, 08:53 AM
Sorted now. Got some 24V bits that'll do the trick.