Martin K
March 7th, 2005, 10:04 AM
We all know the price of cams for these engines from Italy. But how much would you be prepared to pay for 4 cams, ground onto Italian sourced steel billets and properly heat treated afterwards for hardness?
If there are enough people interested to part with (realistic) cash for some cams I believe I can source some at a good price. Profile and lift are almost free, but for example:
Fast road 260 degree cam with inlet lift of 9.95 mm end exhaust lift of 9.39 mm, power band 2000 - 6500 rpm
Race/tarmac rally 300 degree cam with inlet lift of 11.47 mm and exhaust lift of 10.96 mm, power band 3750 - 8000
These are just examples. I'm sure there is a spec for your project engine - even a turbo profile or two should you be going that route.
I'll be looking out for responses, but if you wish to send me a private message please do.
Martin
If there are enough people interested to part with (realistic) cash for some cams I believe I can source some at a good price. Profile and lift are almost free, but for example:
Fast road 260 degree cam with inlet lift of 9.95 mm end exhaust lift of 9.39 mm, power band 2000 - 6500 rpm
Race/tarmac rally 300 degree cam with inlet lift of 11.47 mm and exhaust lift of 10.96 mm, power band 3750 - 8000
These are just examples. I'm sure there is a spec for your project engine - even a turbo profile or two should you be going that route.
I'll be looking out for responses, but if you wish to send me a private message please do.
Martin